POPPUMP Fiji Technical Center

Tel:(001)3474109611

POPPUMP logo

POPPUMP Fiji Technical Center , Discuss Technical Problem , Suply After Service Online of Fuel Dispenser, Please Regist Firstly

F-GA4 FUEL DISPENSER

F-GA4

F-GA4 FUEL DISPENSER

Pump Type: Optional

Inlet Pressure :>=54kPa.

Flow rate (L/min.) :55±5

Suction Distance (m) :6(verticalmente) / 50(orizzontalmente)

FlowMeter Type : Optional

Accuracy :±0.2%

Motor :Voltage(V) 110V/220V/380V,50Hz/60Hz

Capacity(hp) :1HP(0.75kw)

Input Voltage :110V/220V/380V,50Hz/60Hz

Nozzle : Auto Shut-off Nozzle

Environmental Condition : -40~~+55degree

Control Type: Solenold Vale Control Type

Preset :Function Provided(Small LCDIndicator)

Display(Counter) :Type LCD and Bright Backlight

Digit of Volume : 0~~999,999(6 Digits),Decimal point can be changed

Digit of Amount : 0~~999,999(6 Digits),Decimal point can be changed

Digit of Unit price : 0~~9999(4 Digits),Decimal point can be changed

Digit of Total Range :0~~99,999,999,99

Optional :Display Type LCD and Bright Backlight

Digit of Volume : 0~~99,999,999(8 Digits),Decimal point can be changed

Digit of Amount : 0~~99,999,999(8 Digits),Decimal point can be changed

Digit of Unit price: 0~~999999(6 Digits),Decimal point can be changed

Digit of Total Range :0~~99,999,999,99

Totalizer :1~~9,999,999

Hose :4.5m

Weight :350kg

Dimension(L×W×H) :1660*660*2190(mm)

Dimension(L×W×H)Of Qty of Container :40ft: 17

products links

links

technical archives

    where air being exhausted out and oil being left. Whe fuel dispenser n oil level reaching a certain height, oil is controlled by f fuel dispenser loater and returned low pressure chamber. The inlet and outlet pressure disappear after fuel dispenser stopping work, check valve is closed controlled by spring. Thereby the upper oil of check valve can’t flow into high pressure chamber. Meanwhile, the taper valve on floater plug the hole at check valve seat, check valve also shut down under spring function. Under normal working situation of vapor separator, the oil flowed into separate chamber and returned back low pressure chamber should have an equivalent volume so as to ensure the normal working of vapor separator. If the former oil volume is lower than that of latter, the exhausting pipe would flow out oil. If the oil volume in separate chamber is less than the discharge of check valve, check valve would be opened or closed, so that the accuracy of fuel dispenser will be affected due to pump’s fluctuation. If install check valve, the separate function don’t be affected, reducing flow resistance. If don’t mount check valve , However, returned oil would flow out exhausting pipe after stopping fuel dispenser, and appear cavitation in the down stream of vapor separator and pipeline so that affect next measure accuracy. Therefore, mounting a check valve is necessary to fuel dispenser’s normal operation. Some training books call check valve as outlet valve, but in this manual adapts check valve for facilitating understand. Check valve plays role to release the suddenly high pressure so as to protect hydraulic system. 3. Maintenance and troubleshooting Regularly cleaning filter is principal sector of maintenance during operation. New filling station always full of dirty and waste in tank and pipeline, thus, the normal operation of fuel dispensers are affected. Thus, paying much attention to check and clean of filter. As the manufacturers made this kind of vapor separator are many, t fuel dispenser he processing method and product understanding to

technical specification

    n the bus.   The LON chip uses 3 processo fuel dispenser rs and so the communications on the bus (managed by   fuel dispenser 2 of them) never interferes with the transfer of messages with the application   (managed by the third). The forecourt communication expects to use a LON   component for layer 1 to 6 using Explicit Messages.   The length of such messages is set by the Max_Block_Length communication data   element (see chapter 4.5 Communication Service Database). The range for the block   length is 32 to 228. To allow messages longer than this value a Block number BL is   included in the message (for details see chapter 4.4 Block Cutting).  2.2 Application Communication Basics   To avoid specifying message contents where application dependent the choice was to   use a readwrite mechanism.   Six basic messages are used to access any data in the system:   - Read Messages   - Answer Messages   - Write Message   - Unsolicited Data Message with Acknowledge  FP2_1.90 IFSF STANDARD FORECOURT PROTOCOL February 2006   COMMUNICATION SPECIFICATION   Page: 10   - Unsolicited Data Message without Acknowledge   - Acknowledge Message   A Read Message allows an originator device to read the value(s) of any system   data element from a recipient device within a specified database. It is possible to read   multiple data elements in one command. This is achieved by requesting a list of data   elements. So only the accessible data elements must be requested and the messages   are application dependent. The recipient must respond to the Read Message with an   Answer Message within the t fuel dispenser ime-ou

we are committed to create the best workplace, encourage our staffs to put their own personalities into their jobs, and provide them a stage to show themselves.

    passport to ever-higher pay. Now politicians are play fuel dispenser ing on these fears. From the left, populists complain about fuel dispenser Mr Bush s plutocratic friends exporting jobs abroad; from the right, nativists howl about immigrants wrecking the system. A global argument The debate about the American model echoes far beyond the nation s shores. Europeans have long held that America does not look after its poor—a prejudice reinforced by the ghastly scenes after Hurricane Katrina. The sharp decline in America s image abroad has much to do with foreign policy, but Americanisation has also become synonymous with globalisation. Across the rich world, global competition is forcing economies to become more flexible, often increasing inequality; Japan is one example (see article). The logic of many non-Americans is that if globalisation makes their economy more like America s, and the American model is defective, then free trade and open markets must be bad. This debate mixes up three arguments—about inequality, meritocracy and immigration. The word that America should worry about most is the one you hear least—meritocracy. Begin with inequality. The flip-side of America s economic dynamism is that it has become more unequal—but in a more complex way than first appears (see article). America s rich have been pulling away from the rest of the population, as the returns for talent and capital in a global market have increased. Even if American business stopped at the water s edge, Bill Gates and the partners of Goldman Sachs would still be wealthy people; but since software and investment banking are global industries, Mr Gates is worth $50 billion and the average pay-and-benefits package for Goldman s 22,400 employees is above $500,000. On the other hand, the current wave of globalisation may not be widening the gap between the poor and the rest. Indeed, the headwinds of the global economy are being felt less by Americans at the bottom than by fuel dispenser those in the middle. The jobs threatened by outsourc