D-G FUEL DISPENSER

D-G FUEL DISPENSER

Pump Type: Optional

Inlet Pressure : >=54kPa.

Flow rate (L/min.): 55±5

Suction Distance (m): 6(verticalmente) / 50(orizzontalmente)

FlowMeter Type: Optional

Accuracy : ±0.2%

Motor Voltage(V) :110V/220V/380V,50Hz/60Hz

Capacity(hp) :1HP(0.75kw)

Input Voltage : 110V/220V/380V,50Hz/60Hz

Nozzle: Auto Shut-off Nozzle

Environmental Condition: -40~~+55degree

Control Type : Solenold Vale Control Type

Preset: Function Provided(Small LCDIndicator)

Display(Counter): Type LCD and Bright Backlight

Digit of Volume: 0~~999,999(6 Digits),Decimal point can be changed

Digit of Amount : 0~~999,999(6 Digits),Decimal point can be changed

Digit of Unit price : 0~~9999(4 Digits),Decimal point can be changed

Digit of Total Range: 0~~99,999,999,99

Optional Display: Type LCD and Bright Backlight

Digit of Volume: 0~~99,999,999(8 Digits),Decimal point can be changed

Digit of Amount: 0~~99,999,999(8 Digits),Decimal point can be changed

Digit of Unit price :0~~999999(6 Digits),Decimal point can be changed

Digit of Total Range : 0~~99,999,999,99

Totalizer: 1~~9,999,999

Hose: 4.5m

Weight : 205kg.

Dimension(L×W×H): 900*620*2180(mm)

Dimension(L×W×H)Of Qty of Container: 40ft: 45 20ft: 22

is provided for maintenance. Check floater. Disconnect upper cover, check ball floater and returned oil floater and find whether oil flow into floater. Ball floater is made of two brass bowls through welting each other. If welding line exists defect it is easy that oil flow into. It is suggested to change a floater or weld the broken. Putting repaired floater into water more than 80 degree, if found no foam at welding line the repaired one could continue to be used. Some manufacturers replace ball floater, returned oil buoy and exhausting valve seat with ball valve subassembly. Adopting Oil-resistant plastic substitute thin brass board to make returned oil floater. Suggesting change a new floater as found any abnormal transformation of floater. Inspect returned oil valve. There are two situations exhausting pipe leakage caused by the returned oil valve. One situation is that returned oil valve is cemented due to extensive oil. In this case it is suggested to clean valve and reassemble it. Another situation appears because the returned oil valve is stuck. Taking a fuel dispenser way burr or waste on lea fuel dispenser der and reassemble it reference to Diagram 2-13. 3.3 No delivery or inefficient discharge caused by vapor separator Examine filter. A blocked filter not only affects fuel the suction capacity, but also generates abnormal noise. It is suggested to clean and reassemble filter. Don’t use brush to clean metal net so as not to increase net hole and affect filter accuracy. Inspect check valve. If check valve is stuck fuel dispenser can’t discharge any oil. The method to solve the problem is to clean waste after disconnecting spring seat, spring and check valve, and reassemble it. Make sure that the movement of check valve is agile. Inspect the leakage between tank and fuel dispensers. The inspection is conducted with filter check. If no oil or oil level go down slowly in low pressures chamber, there must leakage in bottom valve or pipeline. If there is still leakage occurred after solve above problem, ca fuel dispenser refully examine

ted according to EN 12874.　　 5.3.5.4　　 Inside the hydraulic housing or in any other equivalent area the interface between the vapour recovery　　 5.3.5.5　　 system and the surrounding area shall prevent flame transmission or shall be tight at a pressure of 10 bar as tested　　 according to 6.1.6. Outside this housing upstream of the vapour recovery suction means there is no requirement　　 for flame proof separation.　　 The vapour recovery system shall be protected against flame transmission from one active fuelling　　 5.3.5.6　　 nozzle to another active fuelling nozzle by at least one flame arrester. Vapour pumps certified including flame　　 arresters may be accepted.　　 A flame arrester shall be positioned between any potential source of ignition in normal use of the　　 5.3.5.7　　 metering pumpdispenser and the field connection poi fuel dispenser nt of the vapour pipe.　 fuel dispenser 　 NOTE Necessary actions by customers and testers are normal use; events such as major damage by vehicles or　　 detaching parts of the vapour recovery system for service or maintenance are not normal use.　　 27　　 -- - - ---　　　　　　 Means shall be provided to prevent emission of pressurised vapourair mixture at the inlet of the vapour　　 5.3.5.8　　 recovery system.　　 5.3.6 Housings　　 The housing(s) shall provide mechanical protection against physical contact to the internal equipment.　　 5.3.6.1　　 fuel dispenser

U-shaped table about three days a week, are meant to reach their decisions by consensus. According to Leo Van Houtven, a former secretary of the IMF, a director s influence depends on more than the votes he wields. “Technical expertise is important, persuasiveness counts a great deal, diplomacy, sense of timing, and length of service all have an impact� None of those virtues will appear in the fund s new formula. But they might just help to shape it. © 2006 .  About sponsorship Corporate governance in Brazil Oi! Aug 24th 2006 | SÃO PAULO From The Economist print edition Brazil s shareholding elite receives a black eye from the regulator IT SOUNDED like the sort of thing investors would normally approve of. Telemar, Brazil s biggest telecoms company, decided to get rid of its clunky shareholding structure, involving three different companies and five classes of shares. In its stead, a single enterprise with a svelte new name—Oi—would issue one class of shares on the Novo fuel dispenser Mercado, the part of Bra fuel dispenser zil s stockmarket with the most demanding corporate-governance standards. With this, Telemar would join the fast-growing club of Brazilian enterprises that offer all shareholders perks normally enjoyed by only a few voting rights. But there was a snag. In embracing the new shareholder ethic, Telemar s controllers sought to profit from the old one. Under the share swap proposed in April, investors who now control the company with a financial stake of just 14.7% would own 31% of Oi (assuming that all shareholders participate); other voting shareholders would see their stake rise from 13.8% to 23.7%. But investors in non-voting “preference shares�would be heavily diluted, with their stake tumbling from 71.5% to 45.4%. To sweeten the transaction still more for controlling shareholders, Telemar allowed them to sell shares through a secondary offering. A stockmarket fall in May and June derailed fuel dispenser the s